MAMMUT Silo Fox TITAN
More power and effectiveness for the even distribution of silage
The Silo Fox TITAN differs from the entry-level model CLASSIC in that it has a larger drum diameter and therefore has more material throughput during distribution. The higher net weight (approx. 1,100 kg with water filling) also increases the impact force in the trench silo. All models are available as rear-mounted units or front and rear models with reverse gear.
for tractors with 80 HP and above
Drum diameter = 1,150 mm
for small to medium unloading quantities
available as rear model or front and rear model
Rear model standard equipment | Front and rear model standard equipment |
---|---|
Three-point attachment cat. 2 | Three-point attachment cat. 2 |
Drive shaft | Drive shaft |
Overload protection built into the distributor | Overload protection built into the distributor |
– | Reverse gear for front and rear use |
Spreading width adjustment | Spreading width adjustment |
Water-fillable distributor drum | Water-fillable distributor drum |
Technical data
SF 205 TITAN | SF 245 TITAN | |
---|---|---|
Drum diameter | 1.150 mm | 1.150 mm |
Total drum width | 2.050 mm | 2.450 mm |
Working width | 2.700 mm | 3.100 mm |
Power requirement | ab 80 PS | ab 90 PS |
PTO speed rear/front | 540 / 1.000 | 540 / 1.000 |
Net weight | approx. 690 kg | approx. 790 kg |
Additional weight due to water filling (standard) | ca. 450 kg | ca. 450 kg |
Swivel range to left and right (optional equipment) | ca. 20 ° | ca. 20 ° |
Spreading width adjustment |
Accessories
Pivoting device
Drum widening
Cam clutch
Lighting system
Deflector plate set
Oil drive
Tip: Hydraulic pivoting device
Distributing the feed is made even easier with the hydraulic pivoting device. The pivot point close to the three-point attachment not only makes it possible to have a high lateral offset, but also allows the distributor to be swivelled away from the silo wall easily.
In the case of the Silo Fox TITAN model, the pivoting device is already equipped with two cylinders. Here too, a locking block prevents jerky swivelling movements or unwanted swivelling in of the device. This also makes driving on the road safer.
Cam clutch to prevent damage caused by overloading
The Silo Fox TITAN is protected with a fully integrated overload protection (star ratchet) as standard. As an alternative to the star ratchet, the silage distributor can also be equipped with a cam clutch with even less wear for use on a contract basis.
For driving on the road: optional lighting kit
Travelling on the road with front attachments subjects you to a greater risk of accidents. In order to increase visibility on the road, the Silo Fox TITAN can be upgraded with an optional road lighting system. This equipment is particularly useful for inter-company use of the silage distributor. The driver of the vehicle is always responsible for complying with the relevant road traffic regulations.
If the LED lighting set is additionally combined with the deflector plate package (also optional), the silage spreader can be converted for the distribution process in no time at all: Thanks to magnetic brackets, the lighting kit is easily attached to the machine and then refitted for road travel. This saves a lot of time during harvesting, especially for contractors.
Now NEW: Deflector plate set available
In the course of the new SILO FOX model range, there is also a new accessory: the deflector plate set. This new additional equipment consists of vertical deflector plates at the rear of the machine and a foldable plate at the top of the headstock. Especially with long grass fibres, the deflector plates improve the distribution process by preventing a forage jam and keeping the tractor protected. On request, all models in the SILO FOX series can be equipped with the deflector plate package. Only MAMMUT’s largest distributor, the Silo Fox KOLOSS, is already equipped with it as standard.
Robust oil motor instead of PTO drive
For using the silage spreader on the wheel or telescopic loader, a factory-installed oil motor is available as an alternative to the classic PTO drive. A minimum output of approx. 100 litres/min is required to drive the hydraulic motor for the Silo Fox TITAN model.
MAMMUT provides a wide range of accessories for individual equipment options for wheel loaders and telescopic loaders (attachments, adapters, etc.). We would be pleased to advise you personally or on the phone.